Command Set

PIN xxxx
Purpose: used to change Primary number for host. If submitted Pin is correct then your phone number is set to primary. (Factory default 0000) e.g. PIN 0000

NEWPIN xxxx
Purpose: after setting Primary host number you can now change the pin. e.g NEWPIN 1234

PH1 xxxx …. (min 3 max 11 numbers)
Purpose: from primary number Primary number can be changed. e.g. PH1 +61422123456

PH2 xxxx …. (min 3 max 11 numbers)
Purpose: from Primary number Secondary number can be changed. e.g. PH2 +61422123456

SPEED xxx.x
Purpose: sets and enables the speed alert. Note once alert is activated alert will be disabled.

GEOFENCE
Purpose: sets and enables 1 of 10 geo-fences. Geo-fence 0 is for notify on exit (shared with tow away if enabled). Geo-fence 1-9. is notify on entry.

example 1. GEOFENCE 0 HOME S2723.1234 E15223.1234 5 (where 5 is the radius in Km)
If you having a GPS fix and you want the geo-fence center to be where the vehicle is then you can use the HERE parameter.
example 2. GEOFENCE 0 HOME HERE 5

GEOALLON
Purpose: re-enables all defined geo-fences

GEOALLOFF
Purpose: disables all defined geo-fences

GEOON x
Purpose: enables geo-fence x

GEOOFF x
Purpose: disables geo-fence x

GEOSTATUS
Purpose: displays summary of all geo-fences and whether they are enabled.

GEOREVIEW x
Purpose: displays for review details of geo-fence x

GEONEAR
Purpose: returns nearest geo-fence to the location of your vehicle.

CALLON
Purpose: enables the call on alarm for (geofence,speed,volts,alarm,arm change)

CALLOFF
Purpose: disables the call on alarm.

TOWON
Purpose: enables the towaway detection on arm. This sets a 80 meters radius in position 0.

LOCATION
Purpose: reports back location of vehicle and distance from geo-fence 0

LOCATION x
Purpose: reports back location of vehicle and distance from geo-fence x

DELAYON
Purpose: Enables entry/exit delay approx 35 seconds

DELAYOFF
Purpose: Disables entry/exit delay

ARMON
Purpose: Enables SMS reporting of the arm input wire changing from one state to the other. i.e (gnd to 12v) & (12 to gnd)

STATUS
Purpose: reports back what features are enable

SYS
Purpose: reports back additional feature information including, GPS and GSM signal.

SETGPO xxx
Purpose defines the type for all three general purpose outputs.
C – Cycle (Duty Cycle 1s on 1s Off ~ 30 seconds)
P – 800ms pulse
L – Latch
To set GPO 1 to Pulse, GPO 2 cycle and GPO 3 latch
SETGPO PCL

GPO
Purpose: to enable/disable output with the predefined type P C or L.

e..g. To turn gpo’s 1 to 3 on.

GPO 111 (as defined with SETGPO, GPO 1 will pulse, GPO 2 will cycle and GPO 3 will Latch).

To turn all gpo’s off.
GPO 000.

To turn GPO 1 and 3 on
GPO 101.